4 ENGLISH
WHEEL SANDER SAFETY
WARNINGS
1.
Hold the power tool by insulated gripping sur
-
faces, because the wheel may contact its own
cord.
Cutting a "live" wire may make exposed
metal parts of the power tool "live" and could give
the operator an electric shock.
2.
Always use safety glasses or goggles.
Ordinary eye or sun glasses are NOT safety
glasses.
3.
Inspect for and remove foreign matter such as
nails, screws, etc. from the workpiece surface
before operation.
4.
Secure the workpiece firmly.
5.
Do not wear gloves during operation.
6.
Hold the tool firmly with both hands.
7.
Keep hands away from rotating parts.
8.
Do not leave the tool running. Operate the tool
only when hand-held.
9.
Never attempt to use with the tool held upside
down in a vise, etc.
10.
Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala
-
tion and skin contact. Follow material supplier
safety data.
11.
Use of this tool to sand some products, paints
and wood could expose user to dust contain
-
ing hazardous substances. Use appropriate
respiratory protection.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting front roller
►
Fig.1:
1.
Wing nut
2.
Front roller
The front roller allows you to apply uniform pressure to
the workpiece. To adjust the front roller, set the tool on
a flat surface and loosen the wing nut. Adjust the front
roller up or down until the clearance distance (D) is
about 2 mm. Tighten the wing nut securely.
Switch action
►
Fig.2:
1.
Switch trigger
2.
Lock button
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing wheel
►
Fig.3:
1.
Spindle
2.
Wheel
3.
Output shaft
4.
Hex
wrench
To remove the wheel, insert one hex wrench into the
end of the spindle and another hex wrench into the end
of the output shaft. Turn the hex wrench in the output
shaft clockwise while securely holding the hex wrench
in the spindle so that the wheel cannot revolve. Pull the
output shaft out from the wheel. Move the wheel slightly
away from the spindle and remove the wheel from the
tool.
NOTE:
•
The output shaft has a left hand thread.
To install the wheel, follow the removal procedures in
reverse. When installing it, be sure to align the notches
in the wheel with the pins on the spindle.
►
Fig.4:
1.
Notch
2.
Wheel
3.
Spindle
4.
Pin
