22
Fig.66
(2) 45° bevel angle
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm points to 45° on
the bevel scale on the arm. If the pointer does
not point to 45°, turn, from the underside of
the table, the 45° bevel angle adjusting bolt
on the left side of the sub arm until the pointer
points to 45°.
Replacing carbon brushes
Fig.67
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Fig.68
After use
•
After use, wipe off chips and dust adhering to the
tool with a cloth or the like to assure maximum
service life. Keep the blade guards clean according
to the directions in the previously covered section
titled "Blade guard". Lubricate the sliding portions
with machine oil to prevent rust.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Steel & Carbide-tipped saw blades
•
Vertical vise
•
Hex wrench 6
•
Dust bag
•
Triangular rule
•
Dust cover (Lower blade guard C)
•
Push stick
•
Ruler assembly (Rip fence)
•
Miter gauge
•
Fix plates (3 pieces)
•
Hex bolts (3 pieces)
•
Elbow
•
Top cover assy (Top blade guard)
NOTE:
•
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
