11 ENGLISH
Installing or removing abrasive disc
Optional accessory
NOTE:
Use sander accessories specified in this man
-
ual. These must be purchased separately.
1
2
3
►
1.
Sanding lock nut
2.
Abrasive disc
3.
Rubber pad
1.
Mount the rubber pad onto the spindle.
2.
Fit the disc on the rubber pad and screw the sand-
ing lock nut onto the spindle.
3.
Hold the spindle with the shaft lock, and securely tighten
the sanding lock nut clockwise with the lock nut wrench.
To remove the disc, follow the installation procedure in
reverse.
Installing abrasive cut-off / diamond
wheel
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
WARNING:
NEVER use cut-off wheel for side
grinding.
1
3
2
4
►
1.
Lock nut
2.
Abrasive cut-off wheel / diamond
wheel
3.
Inner flange
4.
Wheel guard for abrasive
cut-off wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
When installing the abrasive cut-off wheel:
1
1
4
4
2
3
►
1.
Lock nut
2.
Abrasive cut-off wheel (Thinner than 4
mm (5/32"))
3.
Abrasive cut-off wheel (4 mm (5/32")
or thicker)
4.
Inner flange
When installing the diamond wheel:
1
1
4
4
2
3
►
1.
Lock nut
2.
Diamond wheel (Thinner than 4 mm
(5/32″))
3.
Diamond wheel (4 mm (5/32″) or thicker)
4.
Inner flange
Installing wire cup brush
Optional accessory
CAUTION:
Do not use brush that is damaged,
or which is out of balance.
Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
1
►
1.
Wire cup brush
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle.
