Makita 1912B, Instruction Manual

4

10. Keep at least 200 mm (8”) away from the tool at

all times.

11. Always switch off and wait for the blades to

come to a complete stop before any adjusting.

12. Never stick your finger into the chip chute.

Chute may jam when cutting damp wood. Clean
out chips with a stick.

13. Do not leave the tool running. Operate the tool

only when hand-held.

14. When leaving the planer, switch off and set it

with the front base up on a wooden block, so
that the blades do not contact anything.

15. Always change both blades or covers on the

drum, otherwise the resulting imbalance will
cause vibration and shorten tool life.

16. Wait for complete run-down before putting the

tool aside.

17. Use only Makita blades specified in this manual.

18. Some material contains chemicals which may be

toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.

SAVE THESE INSTRUCTIONS

WARNING:

MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.

SYMBOLS

USD201-2

The followings show the symbols used for tool.

V

............................volts

A

...........................amperes

Hz

..........................hertz

....................alternating current

.......................no load speed

.......................Class II Construction

.../min

....................revolutions or reciprocation per 

minute

FUNCTIONAL DESCRIPTION

CAUTION:

•

Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Adjusting depth of cut

Depth of cut may be adjusted by simply turning the knob
on the front of the tool.

Switch action

CAUTION:

•

Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the “OFF” position when released.

•

Switch can be locked in “ON” position for ease of
operator comfort during extended use. Apply cau-
tion when locking tool in “ON” position and maintain
firm grasp on tool.

To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.

1. Knob

1. Lock button
2. Switch trigger

1

001603

1

2

001604