14
Place the spring washer (
8
) on the arbour and insert the screw
(
9
) and tighten by hand.
Turn the disc slowly until the stop hole of the V-belt pulley is
visible in the cutting arm cover (
10
).
Insert the Allen key (
2
) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (
1
)
NOTE:
Tighten the screw firmly (30 ± 2 Nm), as otherwise
the cutting wheel may slip during cutting.
Mounting the cutting disc
Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 7.
Unscrew screw (
9
) and remove the spring washer (
8
).
Place the cutting disc (
5
) on the arbour (
7
).
Hinweis:
The arbor hole of the cutting disc must be an exact
fit with the arbor or shaft. If the arbor hole is larger, it must be
fitted with an adapter ring (*).
Make sure the cutting disc is installed so it turns in the right
direction, if a direction is marked on the disc.
PUTTING INTO OPERATION
CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
Sequence
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
4. Adapter ring (not in the general delivery inventory)
Place the Power Cut on a stable surface and carry out the fol-
lowing assembly steps:
Only for models DPC8131 and DPC8132
No air filter is installed!
Before operation, insert an oiled foam filter
(pre-filter)
, as shown in the adjacent illus-
tration! To do this, take off the filter cover
(see the chapter on Cleaning / changing the
air filter)
.
Before taking the foam filter out
of the package, knead it thoroughly.