10
Place the templet guide on the tool base. There are four con-
vex portions on the templet guide. Secure two of the four
convex portions using the two screws. Install the tool base on
the tool.
Secure the templet to the workpiece. Place the tool on the
templet and move the tool with the templet guide sliding
along the side of the templet.
NOTE:
•
The workpiece will be cut a slightly different size from the
templet. Allow for the distance (X) between the router bit
and the outside of the templet guide. The distance (X)
can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router
bit diameter) / 2
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts when
chamfering or grooving.
Attach the guide plate to the straight guide with the bolt, the
wave washer, the flat washer and the wing nut.
1. Templet guide
2. Convex portions
1
2
002007
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
1
2
3
4
5
6
10mm(3/8")
001988
001989
1. Bolt
2. Guide plate
3. Straight guide
4. Flat washer
5. Wave washer
6. Wing nut
1
2
3
4
5
6
001990
Summary of Contents for 3708F
Page 15: ...Memo 15 ...
Page 16: ...Memo 16 ...