8
Installing trimmer shoe (after it has been removed
from the tool)
NOTE:
•
The trimmer shoe is factory installed on the tool.
Use the bolts, wing nuts, spring washers and flat washers to
install the trimmer shoe as shown in the figure.
OPERATION
Turn the tool on without the bit making any contact with the
workpiece and wait until the bit attains full speed. Then move
the tool over the workpiece surface, keeping the tool base
and trimmer shoe flush with the sides of the workpiece.
NOTE:
•
This tool can be used as a conventional trimmer when
you remove the trimmer shoe.
When doing edge cutting, the workpiece surface should be
on the left side of the bit in the feed direction.
1. Bolt
2. Flat washer (large)
3. Trimmer shoe
4. Flat washer (small)
5. Spring washer
6. Wing nut
7. Base
1
2
3
4
5
6
7
002004
1. Trimmer shoe
2. Base
1
2
002005
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
1
2
3
4
4
2
001984
Summary of Contents for 3708F
Page 15: ...Memo 15 ...
Page 16: ...Memo 16 ...