3
ENGLISH (Original instructions)
Explanation of general view
1-1. TEST button
1-2. RESET or "ON" button
1-3. Pilot lamp
1-4. Portable residual current device
(PRCD)
2-1. Wing bolt
2-2. Base
3-1. Wing nut
4-1. Wing bolt
4-2. End of blade case
4-3. Red line
5-1. Base
5-2. Top guide
6-1. Switch trigger
6-2. Lock-off button
7-1. Wrench 22
7-2. Hex wrench
8-1. Inner flange
8-2. Diamond wheel
8-3. Outer flange
8-4. Hex socket head bolt
9-1. Wing bolt
9-2. Blade case
9-3. Water pipe
10-1. Clamp
10-2. Cover (A)
12-1. Clamp
12-2. Cover (A)
13-1. Cover (B)
13-2. Screw
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
SPECIFICATIONS
Model 4101RH
Wheel diameter
125 mm
Max. wheel thickness
2.1 mm
90° 41.5
mm
Max. cutting capacities
45° 26
mm
Max. permitted pressure of water supply
0.14 MPa
Rated speed (n) / No load speed (n
0
) 13,800
(min
-1
)
Overall length
236 mm
Net weight
3.0 kg
Safety class
Class I
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END104-6
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear
safety
glasses.
･
The tool should be used on horizontal
surfaces.
･
Do not use the tool upside down.
･
The tool should be used with the PRCD
(Portable Residual Current Device).
･
Do not use the abrasive cut-off wheel.
･
After use, brush off accumulation of
dust on the base.
･
Do not use the saw blade.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European
Directive, on Waste Electric and
Electronic Equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
ENE023-2
Intended use
The tool is intended for cutting in brick, concrete and
stone.
ENF001-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the
operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's
plug.
