R
epair
P 7 / 15
[7] Disassembling blade holder
[8] Assembling blade holder
1. Disassemble Rod with referring to [ 5] Disassembling Gear housing cover section in page 4.
2. Disassemble Dust cover, and then disassemble Retaining ring R-18 as illustrated in Fig. 18.
Blade holder and Torsion spring 15 are separated from Rod as illustrated in Fig. 19.
1. Apply Makita grease FA No.2 to Push pin.
Insert Push pin to Rod.
Insert the short hook end of Torsion spring 15 to Rod. (Fig. 20)
2. Align the mark of Blade holder and the long hook end of Push pin, and then cover Blade holder on Rod with Torsion
spring 15. (Fig. 21)
3. Bring the long hook end to the space A of Blade holder by turning clockwise. (Fig. 22)
4. Push Rod into Blade holder, and then assemble Retaining ring R-18 to the groove in Blade holder. (Fig. 23)
5. Install Dust cover as illustrated in Fig.24.
Dust cover
Retaining
ring R-18
Rod
Blade holder
Blade holder
Torsion spring 15
Note: Be careful not to lose Push pin when disassembling.
The short hook end
of Torsion spring 15
Fig. 20
Push pin
Push pin
Rod
Hole for
Push pin
Hole for
Torsion
spring 15
The mark of
Blade holder
Blade
holder
Fig. 21
Fig. 22
The long hook end of Torsion
spring 15
Space A
Retaining ring R-18
Dust cover
Press dust cover
to Blade holder.
Fig. 18
Fig. 23
Fig. 24
Fig. 19
The long hook end
of Torsion spring 15
