R
epair
P 8 / 15
[9] Disassembling parts in Gear housing
2. While Locking Crank complete with 1R235, remove two M4x12 Hex socket head bolts. (Fig. 26)
3. Disassemble Retaining S-8. Then, the inner parts are disassembled from Gear housing as illustrated in Fig.27.
Caution: The above M4x12 Hex socket head bolts are threadlocked
with adhesive.
2 pcs. of hex socket
head bolts M4x12
Crank complete
Balance plate
No.1R235
Round bar for arbor
Retaining ring S-8
Retaining S-8
Push plate
Seal plate
Needle bearing 407 (It is easy to drop out of Gear complete.
Therefore, do not miss it.)
Flat washer 8
Gear housing
Balance plate
Gear complete
1. After separating Safety wire from Gear housing cover, remove four 4x16 Tapping screws CT .
Gear housing cover is separated from Gear housing as illustrated in Fig. 25.
Tapping screws
CT 4x16
Gear housing cover
Gear housing
Fig. 25
Fig. 26
Fig. 27