4
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Depth adjustment
1
2
3
4
5
6
1mm
013634
The depth can be adjusted by turning the front cover.
Loosen the lock ring, which locks the front cover, by
turning it clockwise.
Turn the front cover so that the screw head protrudes
approximately 1 mm from the stop ring.
After adjusting the front cover, tighten the lock ring firmly
against the front cover so that the front cover does not
move.
Drive a trial screw into your material or a piece of
duplicate material. If the depth is not suitable for the
screw, continue adjusting until the proper depth setting
is obrained.
0.5mm
1
2
3
4
5
6
013635
When using a socket bit, turn the front cover so that the
hex bolt head protrudes approximately 0.5 mm from the
stop ring.
Switch action
1
2
013638
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
•
Even with the switch on and motor running, the bit
does not rotate until you fit the point of the bit in
the screw head and apply forward pressure to
engage the clutch.
Reversing switch action
1
013636
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
This tool has a reversing switch to change the direction
of rotation. Press the "R" side of the reversing switch for
clockwise rotation, and or the "L" side for
counterclockwise rotation.
1. Bit
2. Lock ring
3. Clutch cover
4. Front cover
5. Stop ring
6. Self-drilling
screw
1. Socket bit
2. Lock ring
3. Hex bolt
4. Stop ring
5. Front cover
6. Clutch cover
1. Switch trigger
2. Lock button
1. Reversing
switch
