5
1
2
3
011581
Setting for desired screw length
1
2
3
4
006802
There are 3 positive-lock screw length settings. To obtain
the desired setting, pull out the stopper base while
depressing the lever until you see the number of the
desired screw length (indicated on the plate) appear to
rest on the very top edge of the casing.
See the table below for the relation between the number
indicated on the plate and the respective screw length
ranges.
Number indicated on the plate
Screw length range (mm)
25/28
25 - 28
32
28 - 35
40
35 - 41
011616
Adjusting the driving depth
Depress the stopper base as far as it will go. While
keeping it in this position, turn the adjusting knob until the
bit tip projects approx. 5 mm from the stopper base. Drive
a trial screw. If the screw head projects above the driving
surface, turn the adjusting knob in the A direction; if the
screw head is countersunk, turn the adjusting knob in the
B direction.
5mm
A
B
1
2
3
006803
Installing screw strip
1
2
3
011582
1
011579
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
Removing screw strip
To remove the screw strip, just pull it out in the direction
of the arrow.
011583
If you depress the reverse button, you can pull out the
screw strip in the reverse direction of the arrow.
1
011584
1. Reverse button
1. Driving position
1. Feeder box
2. Screw strip
3. Screw guide
1. Stopper base
2. Casing
3. Adjusting knob
1. Lever
2. Stopper base
3. Plate
4. Casing
1. Plane bearing
2. Dust cover
3. Bit
