Adjusting the angle head (Fig. 4 & 5)
Important:
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting the
angle head.
The angle head can be adjusted 360° (8 positions in
45-degree increments). To adjust it, loosen the hex
bolt and remove the angle head. Adjust the angle
head to the desired position and reinstall it so that the
teeth on the housing will match up with the grooves in
the angle head. Then tighten the hex bolt to secure
the angle head.
Switch action (Fig. 6)
CAUTION:
Before inserting the battery cartridge into the tool,
always check to see that the switch lever actuates
properly and returns to the ‘‘OFF’’ position when
released.
To start the tool, move the release button forward (A
direction) and squeeze the switch lever. Tool speed is
increased by increasing pressure on the switch lever.
To
stop
the
tool,
release
the
switch
lever.
CAUTION:
After switching off, always move the release button
backward (B direction) to prevent the tool from being
accidentally switched on.
Reversing switch (Fig. 6)
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes to
a complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
This tool has a reversing switch to change the direc-
tion of rotation. Slide the reversing switch down
(Position F) for clockwise rotation or slide it up
(Position R) for counterclockwise rotation.
Operation
The proper fastening torque may differ depending
upon the kind or size of screws, the type of materials
to be fastened, etc. Before starting your job, always
perform a test operation to verify adequate fastening
torque.
Straight head and ratchet head (Fig. 7 & 8)
Straight heads and ratchet heads are available as
optional accessories for various applications on the
job.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
6940D/DW (E) (’100. 3. 15)
5
Summary of Contents for 6940D
