4
ENGLISH (Original instructions)
Explanation of general view
1-1. Shaft lock
2-1. Slide switch
3-1. Indication lamp
(speed adjusting dial)
4-1. Indication lamp
5-1. Speed adjusting dial
7-1. Wheel guard
7-2. Bearing box
7-3. Screw
7-4. Lever
8-1. Screw
9-1. Lock nut
9-2. Depressed center grinding wheel
9-3. Inner flange
10-1. Lock nut wrench
10-2. Shaft lock
11-1. Lock nut
11-2. Abrasive disc
11-3. Rubber pad
12-1. Marking A
13-1. Marking B
14-1. Marking C
15-1. Pin
15-2. Vent
17-1. Wire cup brush/Wire bevel brush
18-1. Lock nut
18-2. Abrasive cut-off wheel/
diamond wheel
18-3. Inner flange
18-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
19-1. Exhaust vent
19-2. Inhalation vent
SPECIFICATIONS
Model 9566CR
9566CVR
Depressed center wheel diameter
150 mm
150 mm
Max. wheel thickness
6.4 mm
6.4 mm
Spindle thread
M14
M14
Rated speed (n) / No load speed (n
o
) 10,000
min
-1
10,000
min
-1
Overall length
299 mm
299 mm
Net weight
2.4 kg
2.4 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE048-1
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN60745:
Sound pressure level (L
pA
) : 86 dB (A)
Sound power level (L
WA
) : 97 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : surface grinding with anti vibration
side grip
Vibration emission (a
h,AG
) : 6.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode : surface grinding with normal side
grip
Vibration emission (a
h,AG
) : 7.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode : disc sanding
Vibration emission (a
h,DS
) : 2.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG902-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
•
The declared vibration emission value is used for
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
