9
dispose of the solvent used in a safe and prudent
manner and in compliance with all local and national
code requirement.
Fig.15
Dry off the tool before use. Any oil film left after cleanup
will accelerate the tar buildup, and the tool will require
more frequent recleaning. After drying off the tool, oil the
moving parts to prevent rusting and to assure good
lubrication and operation or moving parts. Install the
contact element on the driver guide. Press the knob
toward the nose tip and turn the knob clockwise to
secure.
WARNING:
•
Never use gasoline or other similar highly volatile
liquids for cleaning. Vapors of such liquids may
enter the tool and could be ignited by sparks
produced during nailing and cause an explosion.
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
Fig.16
Make sure all safety systems are in working order before
operation. The tool must not operate if only the trigger is
pulled or if only the contact element is pressed against
the wood. It must work only when both actions are
performed. Test for possible faulty operation with nails
unloaded.
Ba
n
g!
005638
Ba
n
g!
005639
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to direct sunlight
and/or humid or hot environment.
Fig.17
Fig.18
Maintenance of compressor, air set and air
hose
Fig.19
Fig.20
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool, It
may result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic oil
in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
Fig.21
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which
it may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges
and areas which may lead to damage or abrasion to the
hose.
Stove
Thinner
004320
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Nails
•
Air hoses
•
Nose adapter
•
Safety goggles
NOTE:
•
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Summary of Contents for AN451
Page 58: ...58 ...
Page 59: ...59 ...
Page 60: ...60 Makita Corporation Anjo Aichi Japan www makita com 883862A984 ...
