18
010824
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Cutter blade
• Nylon cutting head
• Pole hedge trimmer attachment (for model BBC300L,
BC300LD)
• Pole saw attachment (for model BBC300L, BC300LD)
• Cultivator attachment (for model BBC300L, BC300LD)
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Malfunction status
Cause
Action
Motor does not run.
Battery cartridge is not installed.
Install the battery cartridge.
Battery problem (under voltage)
Recharge the battery. If recharging is
not effective, replace battery.
The drive system does not work
correctly.
Ask your local authorized service
center for repair.
Motor stops running after a little use.
Rotation is reverse.
Change the direction of rotation with
the reversing switch.
Battery’s charge level is low.
Recharge the battery. If recharging is
not effective, replace battery.
Overheating.
Stop using of tool to allow it to cool
down.
It does not reach maximum RPM.
Battery is installed improperly.
Install the battery cartridge as
described in this manual.
Battery power is dropping.
Recharge the battery. If recharging is
not effective, replace battery.
The drive system does not work
correctly.
Ask your local authorized service
center for repair.
Cutting tool does not rotate:
stop the machine immediately!
Foreign object such as a branch is
jammed between the guard and the
nylon cutting head or cutter blade.
Remove the foreign object.
Cutter blade fastening nut is loose.
Tighten the nut properly as described
in this manual.
The cutter blade is bended.
Replace the cutter blade.
The drive system does not work
correctly.
Ask your local authorized service
center for repair.
Abnormal vibration:
stop the machine immediately!
One of nylon cord has been broken
and the head got unbalanced.
Bump the nylon cutting head against
the ground while it is rotating to cause
the cord to feed.
The cutter blade is bended, cracked or
worn.
Replace the cutter blade.
Cutter blade fastening nut is loose.
Tighten the nut properly as described
in this manual.
Cutter blade is fastened improperly.
The drive system does not work
correctly.
Ask your local authorized service
center for repair.
Cutting tool and motor cannot stop:
Remove the battery immediately!
Electric or electronic malfunction.
Remove the battery and ask your local
authorized service center for repair.
