R
epair
P 10 / 15
Fig. 47
Fig. 48
Fig. 49
Fig. 50
( 9) Insert armature in yoke unit. And mount endbell to the commutator side of armature. See Fig. 47.
The assembling of motor section has been completed in this step.
(10) Join the motor section to the gear section. See Fig. 48.
(11) Facing switch unit to the plate installing side, mount the motor and gear section to housing R.
and put ON/OFF switch with F/R change lever, buzzer circuit and terminal into housing R.
Contain LED circuit into housing R. See Fig. 49.
(12) Mount plate and lens. And secure housing L with 8 pcs. of pan head screw M3x20. See Fig. 50.
End bell
Armature
Yoke unit
<Note>
Be careful, not to be pinched your finger
between yoke unit and armature.
Because, armature is pulled toward yoke
unit by the strong magnetic force.
Gear section
Motor section
Controller
Switch unit
F/R change lever
ON/OFF switch
Buzzer circuit
Terminal
Plate
Lens
Housing L
LED circuit
