R
epair
P 6 / 15
(5) Insert hex wrench into the hole of spindle and hold the hex wrench with vise. Insert torx wrench T25 into
the hole of torx counter sunk head screw M5x10. And turn torx wrench T25 anti-clockwise. See Fig. 20.
(6) After removing torx counter sunk head screw M5x10, the clutch section can be disassembled in the order of
flat washer 7, steel balls 3.0, cam A and steel balls 4. See Fig. 21.
Remove steel balls 5. Then, cam B can be removed from spindle. See Fig. 22.
Torx counter sunk
head screw M5x10.
Torx counter sunk
head screw M5x10.
Hex wrench
Torx wrench T25
6mm
Steel balls 3.0
(13 pcs.)
Flat washer 7
Cam A
<Note>
Pay attention, not to lose steel
balls, when disassembling.
Use the hex wrench with the
following size.
Steel ball 4
(3 pcs.)
Cam B
Steel ball 5
(3 pcs.)
Cam B
Spindle
Fig. 20
Fig. 21
Fig. 22
Fig. 23
< 7 > Assembling clutch section
(1) Before mounting, take the following steps. See Fig. 23.
1. Apply MAKITA grease N. No.2 to 3 pcs. of steel balls 5 and 3 pcs. of steel ball 4.
2. For effective adhesion, clean the screw hole of spindle and torx counter head sunk screw M5x10 with petrol.
Spindle
Torx counter sunk
head screw M5x10
Screw hole for
torx counter sunk head
screw M5x10
