Makita BHR261, Technical Information

P 1

4

/ 2

1

R

epair

[3] DISASSEMBLY/ASSEMBLY
[3]-7. Impact bolt in Tool holder complete (BHR261)/ Tool holder guide complete (BHR261T)

DISASSEMBLING

(1) When Striker is left in Tool holder (guide) complete, push Striker out of Tool holder (guide) complete by inserting 1R281
      from the top end and striking the 1R281 with plastic hammer. 
(2) Remove Tool holder (guide) section as mentioned in the clause of 

[3]-5

.

(3) Remove Ring spring 28 from Tool holder (guide) complete and disassemble Impact bolt section. (

Figs. 39 to 42

)

[Cap 35 side]

[Inner housing complete side]

Ring spring 28

Ring spring 28 can be pulled off from Tool
holder (guide) complete when completely 
remove from the groove. 

Disassemble Impact bolt
section by striking Tool 
holder (guide) complete 
against workbench.

Note: 

Be sure to replace Ring spring 28

           when assembling Tool holder (guide) 
           section. 

Fig. 41

Fig. 42

Tool holder 
(guide) complete

Sleeve 9

Impact bolt

Ring 10

Cushion ring 13

O ring case with
O ring 9 fit inside

Impact bolt section

Fig. 40

Fig. 39

clearance of Ring spring 28

Ring spring 28

Note

: When the clearance of Ring spring 28

          is  in the hole, slide the clearance to 
          the blind side using a slotted screwdriver.  

Ring spring 28

1R038

Vise

Tap Ring spring 28 from the two holes alternately to push
downward. 

Tool holder complete

Tool holder (guide) complete