P 4 / 14
R
epair
[3] -1. Blade Clamp Section (cont.)
ASSEMBLING
Fig. 8
1) Assemble Torsion spring 17 to Slider as illustrated in Fig. 7.
Important: Be sure that Torsion spring 17 is not reversible when assemble to Slider.
Follow the instruction described in Fig. 7.
2) Insert Compression spring 2 into the slit of Slider.
3) Install Sleeve on Slider, and lock Pin 3 provisionally by turning Sleeve clockwise. (Fig. 8)
4) Mount Guide sleeve provisionally, then put Push plate into the slit of Slider as illustrated to left in Fig. 9.
Important: Be sure that Push plate is not reversible when installed.
While pushing Push plate straight into Slider with recipro saw blade, insert Pin 3 (of 19.8mm length) through the hole
of Push plate as illustrated to right in Fig. 11. Then remove Guide sleeve.
Note: Guide sleeve is used as a jig, not assembled to Slider yet in this step.
Pin 3, 19.8mm long
Sleeve
Slider
Fig. 9
This projection must
face the blade side.
Push plate
Guide sleeve
Recipro saw blade
Fig. 7
Insert this end
into the slit of
Slider.
This end has to
be positioned
on the Cap side.
Shift button
Slider
Torsion spring 17
Cap
[Side view of cap]
Cap has an insert hole
for Shift button.
Pin 3, 19.8mm long
insert pin 3 through
the hole of push plate.
While pushing recipro saw blade,