P 7 /14
R
epair
Fig. 18
DISASSEMBLING
ASSEMBLING
[3] -3. Slider Section (cont.)
Plane bearing 14A
Do the reverse of disassembling steps.
Note:
a) Do not forget to apply Makita grease FA No.2 to slider before assembling. (Fig. 19)
b) Both of the two 14A Plane bearings are not reversible when assembled to Slider.
Be sure to assemble as illustrated in Fig. 20.
Plane bearing 14A
Slider
While raising this
end, pull off Slider.
Push Slider toward
the Motor housing side.
Remove Plane bearing 14A
on the Motor housing side.
6) Remove two Plates from Gear housing cover complete
by unscrewing four M5x16 Pan head screws. (Fig. 17)
Note: It is recommended to use impact driver to
remove the screws because they are coated with
threadlocker.
7) Disassemble Slider as illustrated in Fig. 18.
Surface that contacts
Plane bearing 14A: a little amount
Surface that contacts
Needle bearing 708: approx. 7g
Fig. 19
Gear housing cover side
Motor housing side
Blade clamp side
Gear housing side
Stepped portion
Plane bearing 14A
Slider
Plane bearing 14A
Fig. 20
Pan head screw M5x16,
threadlocker coated
Plane bearing
14A
Gear housing
cover complete
Slider
Fig. 17
Plate
Plate
Plane bearing
14A
Stepped portion