P 7/ 9
1) Remove DC motor section in accordance with
the clause [4]-2
.
2) Disassemble Gear section as illustrated in
Fig. 23
.
3) Remove Leaf spring from Housing L. (
Fig. 24
)
4) Cover the pins of Spur gear 7 complete with Internal gear 69. Refer to the direction of Internal gear 69. (
Fig. 23
)
5) After inserting the pins of Spur gear 7 complete into Spur gears 27 (3pcs.), mount Flat washer 12 on Internal gear 69.
6) Install the assembled parts (Flat washer 12, Internal gear 69, Spur gear 27 (3pcs.) and Spur gear 7 complete) into
Housing L so that the large protrusion of Internal gear 69 can be seen. (
Fig. 25
)
7) Insert Leaf spring into Housing L. (Inserting Leaf spring into Housing L before installation of the assembled parts
causes difficulty.)
8) Plate and Spur gear 55 complete have to be fixed as illustrated in
Fig. 26
. Refer to their directions.
DC motor
Leaf spring
large protrusion of Internal gear 69
(small protrusion)
Sleeve 5
Flat washer 10
Plate
Spur gear 55 complete
(To Housing L: Refer to
Fig. 18
)
Flat washer 12
Internal gear 69
Note
: Apply a little amount of Makita grease N No.2 to the inner periphery.
[4] DISASSEMBLY/ ASSEMBLY
[4]-5. Replacing Gear section
R
epair
Fig. 23
Fig. 24
Fig. 24
Fig. 26
Spur gear 27 (3pcs.)
Flat washer 10
Plane bearing 10
Spur gear 7 complete
Note
: Apply a little amount of Makita grease
N No.2 to the pins.
4x18 Tapping screw
Pin10