P 1
0
/1
0
W
iring diagram
Switch
Brush holder complete
Lead wire holder
Lead wire holder
LED
pin
boss
Connector (large)
Connector (small)
Light circuit
rib
Terminal side
Switch side
Lead wire holder
Terminal
Fig. D-2
1. Lead Wires of LED
2. Other Lead Wires
Fix LED lead wires (red, black) with lead wire holder,
then route between pin and boss as illustrated below.
Assemble each Connecting
terminal to Switch at approx.
20 degrees to the vertical.
Fix the lead wires connected
to each connector with these
lead wire holders.
Put Light circuit in place
so that the orange lead wire
faces toward the Terminal side.
Lead wire
(orange)
20 degrees
Do not cross LED lead wires (red, black) here.
LED
Fit the corner of LED against the corner
of Housing (L) as illustrated below.
Do not slack LED lead wires
(red, black) in this area.
Put the following lead wires
between the rib and Light circuit.
* Lead wires (red, black) from
Terminal to Connector (small)
* Lead wire (blue) from Switch
to Connector (small)
Pin
The lead wire (blue) from
Connector to Switch has to
be routed inside of this pin.
