8 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
CE001G
Wheel diameter
355 mm
Max. wheel thickness
5.0 mm
Max. cutting depth
127 mm
Rated speed
5,300 min
-1
Rated voltage
D.C. 72 V - 80 V max
Max. permitted pressure of feed-water
5.0 bars
Overall length
786 mm
Net weight
12.3 - 12.9 kg
Protection degree
IPX4
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi
-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL4040 / BL4050F*
* : Recommended battery
Charger
DC40RA / DC40RB / DC40RC
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above.
Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for cutting in metal materials with
an abrasive cut-off wheel and also masonry materials
with a diamond wheel.
Noise
The typical A-weighted noise level determined according to EN60745-2-22:
Sound pressure level (L
pA
) : 109 dB(A)
Sound power level (L
WA
) : 120 dB (A)
Uncertainty (K) : 3 dB(A)
NOTE:
The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE:
The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual use of the power tool can differ from the declared val
-
ue(s) depending on the ways in which the tool is used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
Summary of Contents for CE001G
