9
Indicating the remaining battery capacity (Fig. 4)
Only for battery cartridges with the indicator
Press the check button (17) on the battery cartridge to indicate the remaining battery capacity. The indicator lamps
(16) light up for few seconds.
Indicator lamps
Remaining capacity
Lighted
Off
Blinking
75 % to 100 %
50 % to 75 %
25 % to 50 %
0 % to 25 %
Charge the battery.
(For 18 V and 14.4 V batteries only)
The battery may have malfunctioned.
(For 18 V and 14.4 V batteries only)
NOTE:
•
Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual
capacity.
Appliance / battery protection system
The appliance is equipped with the protection system. This system automatically cuts off power to the motor to
extend appliance and battery life. The appliance will automatically stop during operation if the appliance or battery is
placed under one of the following conditions.
- Overload protection : When the appliance is operated in a manner that causes it to draw an abnormally high
current, the appliance automatically stops without any indication. In this situation, turn the appliance off and stop
the application that caused the appliance to become overloaded. Then turn the appliance on to restart.
- Overheat protection : When the appliance is overheated, the appliance automatically stops. Let the appliance cool
down before turning it on again.
- Overdischarge protection : When the battery capacity becomes low, the appliance stops automatically. If the
appliance does not operate even when the switches are operated, remove the battery cartridge from the appliance
and charge it.
Starting / stopping the fan (Fig. 1, 2)
Push the power switch button (1) to turn on the fan. Push the power switch button again to turn off the fan.
Changing wind speed (Fig. 5)
Push the wind speed change button (2) while the fan is running. The wind speed increases every time you push the
button. The wind speed will return to the lowest speed when running in the highest speed.
The cordless fan will start in the same speed as the previous setting.
Adjusting fan head angle (Fig. 6, 7)
The angle of the fan head can be adjusted manually. The range of motion in the fan head is as shown in the figure.
For DCF102, press and hold the release button (8) when adjusting the fan head angle.
NOTE:
Do not turn the fan head further than its range of motion.
Oscillating the fan head (Fig. 8)
Push the oscillation button (4) to oscillate the fan head. Push the button again to stop the oscillation.
The fan head begin to oscillate from the current position when the oscillation button is pushed. The fan head oscillate
90-degree angle of range.
