7 ENGLISH
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To start the cutting operation, continue to pull the switch trigger.
The cutting die on the movable mount will overlap with the die on
the stationary mount and then returns. If you release the switch
trigger before completing the cut, the cutting dies will stop.
1
►
1.
Switch trigger
1
3
2
►
1.
Stationary mount
2.
Cutting die
3.
Movable mount
NOTICE:
Do not operate the tool at no-load
unnecessarily.
Auto-stop function
When you continue to pull the switch trigger, the jaw of the dies once
closes and returns to fully opened position then stops. Release the
trigger and pull it again to begin the next cutting sequence.
Reversing switch lever
WARNING:
When not operating the tool,
always set the reversing switch lever to the lock
position.
CAUTION:
Always make sure the position of
the reversing switch lever before operating.
NOTICE:
Do not move the reversing switch lever
when the switch trigger is being pulled.
This may
cause a damage to the tool.
To start the cutting operation, set the reversing switch
lever to cutting position.
To reverse the cutting sequence, set the reversing
switch lever to the reversing position. When you con
-
tinue to pull the switch trigger, the jaw of the cutting die
opens and stops at fully opened position.
To lock the switch trigger, set the reversing switch lever to the
lock position. The switch trigger cannot be pulled in this position.
1
2
3
4
►
1.
Reversing switch lever
2.
Cutting position
3.
Lock
position
4.
Reversing position
NOTICE:
When the reversing switch lever is in the
reversing position, run the tool only as needed.
To
prevent the damage to the tool, the tool will automatically
stops when it is run in the reversing position continuously.
NOTE:
After cutting, if you release the switch trigger while
the jaw of the cutting die is opening and then set the revers
-
ing switch lever to the reversing position, the jaw will once
close and then open when you pull the switch trigger again.
LED light
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp keeps on
lighting while the switch trigger is being pulled. The lamp goes
out approximately 15 seconds after releasing the switch trigger.
1
►
1.
Lamp (inside)
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE:
When the tool is overheated, the lamp will
blink. Let the tool cool down in this case.
