10 ENGLISH
Removing nozzle
Hold the nozzle end and rotate it in a direction indicated
by the arrows on the nozzle end to release the lock. Pull
the nozzle apart from the lock sleeve after it becomes
unlocked.
2
1
Fig.2
►
1.
Nozzle end
2.
Lock sleeve
NOTICE:
Adhered dirt and dust on the surface
will possibly make it hard to remove the nozzle
from the tool. In such a case, slide and hold the
lock sleeve towards the motor housing first, and
then turn the nozzle end to release the lock.
CAUTION:
Be careful not to pinch your hands
between the rear end of the lock sleeve and motor
housing while removing the nozzle.
The lock
sleeve slides back towards the motor housing when
the nozzle is released from the lock.
1
2
Fig.3
►
1.
Lock sleeve
2.
Motor housing
Removing and installing dust cap
1.
Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
1
2
3
4
Fig.4
►
1.
Dust cap
2.
Locking tabs
3.
Suction inlet
4.
Guide
grooves
2.
Reassemble the dust cap onto the suction inlet,
aligning the two locking tabs on the dust cap with the
guide grooves on the housing. Then turn the dust cap
clockwise to secure it in place.
2
4
3
1
Fig.5
►
1.
Dust cap
2.
Locking tabs
3.
Suction inlet
4.
Guide
grooves
