P 18/ 24
R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-6. Adjuster
DISASSEMBLING
ASSEMBLING
Following the steps mentioned in Fig. 16 of
page 14
, remove Switch base.
And then, remove Adjuster as drawn in
Fig. 20
.
1. Remove Urethane ring 4, and then
separate Arm from Adjuster rod.
2. Turn Adjuster in direction of the black arrow to the full by a finger.
In this condition, turn the flats of Adjuster rod in direction of
the gray arrow with Wrench 8.
3. Adjuster and the relative parts are removed as drawn below.
Fig. 20
Refer to
Figs. 21
.
Fig. 21
Adjuster rod
Wrench 8
Adjuster
Flats of Adjuster rod
Adjuster rod
Urethane
ring 4
Arm
Urethane ring 4
Adjuster
The module of Adjuster,
Compression spring 2,
Steel ball 2.3 and
Adjuster guide (See
Fig. 20
.)
Adjuster
Adjuster block
Switch base
Compression spring 2
Steel ball 2.3
Adjuster guide
Adjuster rod
Adjuster guide
1. Insert Urethane ring 4
into Adjuster block.
2. Insert the above module
diagonally into Switch
base.
4. Assemble Adjuster section to Switch base.
5. Insert Adjuster rod into Urethane ring 4 in Adjuster block by
pushing the Adjuster rod end by a finger in direction of gray arrow
while turning Adjuster in direction of black arrow.
3. Assemble Adjuster block to Switch base
by turning the Adjuster block.
Urethane
ring 4
