P 5/ 24
R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-1. Magazine section
DISASSEMBLING
(1) Remove Magazine section, and then separate Slide door from Magazine. (
Fig. 3
)
Fig. 3
Fig. 3
Fig. 3
M4x12 Pan head screw
(2 pcs.)
Magazine
section
Driver guide section
Magazine
section
Magazine
M5x20 Hex socket head bolt
(2 pcs./ Thread-locker type)
[7.5-9.0 N·m]
M4x8 Hex socket
head bolt (2 pcs.)
[2.7-4.2 N·m]
M4x6 Hex socket
head bolt
M4x6 Hex socket head bolt (2 pcs.)
[2.7-4.2 N·m]
Plate A
Nail plate
Magazine
Center plate complete
Set plate
Set plate
Plastic hammer
Compression spring 4
Driver guide
M4x10 Hex socket head bolt
Slide door
Slide door
1. Remove two M4x12 Pan head screws.
3. Remove Magazine section.
5. Remove an module (Driver guide, Center plate
complete and Compression spring 4) from Set plate.
2. Remove M4x6 Hex socket head bolt and two M5x20 Hex socket head
bolts (Thread-locker type). Then, disassemble Driver guide section.
4. Remove two M4x6 Hex socket head bolts and Plate A.
6. Remove two M4x8 Hex socket head bolts and separate
Set plate from Magazine.
Note
: The fitting between Set plate and Magazine is tight,
and therefore, tap Set plate with a plastic hammer.
7. Remove Nail plate from Magazine section.
8. Remove M4x10 Hex socket head bolt, and then
pull out Slide door from Magazine.
