4
8.
Keep hands and feet away from the ejection
port area.
9.
Follow instruction for lubricating and
changing accessories.
10.
Always remove the battery cartridge before
loading the fasteners, adjustment, inspection,
maintenance or after operation is over.
11.
Make sure no one is nearby before operation.
Never attempt to drive fasteners from both the
inside and outside of wall at the same time.
Fasteners may rip through and/or fly off,
presenting a grave danger.
12.
Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
13.
Never use fastener driving tools marked with
the symbol "Do not use on scaffoldings,
ladders" for specific application for example:
−
when changing one driving location to another
involves the use of scaffoldings, stairs, ladders,
or ladder alike constructions, e.g. roof laths;
−
closing boxes or crates;
−
fitting transportation safety systems e.g. on
vehicles and wagons.
14.
Check walls, ceilings, floors, roofing and the
like carefully to avoid possible electrical
shock, gas leakage, explosions, etc. caused
by stapling into live wires, conduits or gas
pipes.
15.
Use only fasteners specified in this manual.
The use of any other fasteners may cause
malfunction of the tool.
16.
Do not tamper with the tool or attempt to use
it for other than driving fasteners.
17.
Do not operate the tool without fasteners. It
shortens the service life of the tool.
18.
Stop driving operations immediately if you
notice something wrong or out of the ordinary
with the tool.
19.
Never drive fastener into any materials which
may allow the fastener to puncture and fly
through as a projectile.
20.
Never actuate the switch trigger and safety
lever at the same time until you are prepared
to fastener workpieces. Allow the workpiece
to depress the safety lever. Never defeat its
purpose by securing the safety lever back or
by depressing it by hand.
21.
Never tamper with the safety lever. Check the
safety lever frequently for proper operations.
22.
Always remove fasteners from the tool when
not in use.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
USD501-3
Symbols
The followings show the symbols used for tool.
･
Read and understand tool labels and
manual.
･
Operators and others in work area
must wear safety glasses with side
shields.
･
Keep fingers away from trigger when
not driving fasteners to avoid accidental
firing.
･
volts
･
direct
current
ENC007-8
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1.
Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
2.
Do not disassemble battery cartridge.
3.
If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4.
If electrolyte gets into your eyes, rinse them
out with clear water and seek medical
attention right away. It may result in loss of
your eyesight.
5.
Do not short the battery cartridge:
(1)
Do not touch the terminals with any
conductive material.
(2)
Avoid storing battery cartridge in a
container with other metal objects such
as nails, coins, etc.
(3)
Do not expose battery cartridge to water
or rain.
A battery short can cause a large current flow,
overheating, possible burns and even a
breakdown.
Summary of Contents for DBN500Z
Page 31: ...31 ...
