OFFICIAL USE
for ASC & Sales Shop
40 / 41
8
WIRING DIAGRAM
Fig. 77
●
Put lead wires connected
to Connector A, B in these
lead holders.
LED
●
Put Connector C and lead wires connected to Print
board in lead holder A, lead holder B, groove C and
groove D.
●
Put lead wires connected to
Print board on the upper side
of Connector C.
●
Put lead wires connected to Print board and Connector C in
the gap between Rib A, Rib B, Rib C and the inner wall
of Housing.
Rib A
●
Put lead wires for Switch unit (for Contact arm) in
these grooves.
Connector A, B
(
2 Pin & 3 Pin)
Switch unit
(
for Contact arm
)
Switch unit
(
for Trigger
)
Housing L
●
Put LED in Housing L so that the lead
wire comes from the back side.
●
Connect Flag receptacles that are connected to
Mode selection switch so that lead wires come as
illustrated.
●
Put Controller so
that the lead wires
that come from
Controller fit in the
Housing L side.
Mode selection
switch
Rib B
Rib C
Groove A
Groove C
Connector C
Lead holder B
Lead holder A
●
Put
lead
wires
connected to LED in the
groove A and B.
Controller
Print board
Groove B
Groove D
●
Put Print board as shown
so that the protrusion faces
Housing L side.
Housing L side
Housing R side
Print board
Protrusion