7
1
2
3
008931
2. Insert the protrusion of the dust pack into the
groove in the dust stopper as shown in the figure.
1
008932
3. There is no distinction between the upper and
lower sides of the dust pack. You may insert its
protrusion of any side into the lower groove of the
dust stopper.
008933
4.
Overlap the frame of dust stopper with that of the
dust pack.
1
011554
5.
Place the dust stopper and the dust pack together
into the cleaner cavity in the same direction of
arrow on the dust stopper. Insert them all the way
into the slots in the cleaner cavity.
011555
6.
Place the entire container part of the dust pack
inside the tool itself.
7.
Close the front cover completely.
CAUTION:
•
Forgetting to install the dust bag or the dust pack,
failure to insert the dust stopper together with the
dust bag or the dust pack all the way into the slots
or using a broken or ripped bag, may allow dust to
get into the motor. This may result in motor failure.
•
Do not fold the cardboard at its opening when
installing the paper pack, .
•
Never throw away the dust stopper because it need
to be used repeatedly whenever either the dust bag
or the dust pack is used.
•
The paper pack for the cleaner is an important
component for maintaining the tool performance.
Using other than the genuine paper pack may
cause smokes or ignition.
OPERATION
CAUTION:
•
To connect attachments, such as nozzle,
twist-insert attachment in direction of arrow to
ensure secure connection during use. To
disconnect attachment, twist-extract also in
direction of arrow.
011543
1. Cleaner cavity
1. Lower groove
1. Dust stopper
2. Dust pack
3. Groove
Summary of Contents for DCL182
Page 31: ...31 ...
