5
Model DGA404
Work mode : surface grinding with normal side
grip
Vibration emission (a
h,AG
) : 4.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode : surface grinding with anti vibration
side grip
Vibration emission (a
h,AG
) : 4.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode: disc sanding
Vibration emission (a
h,DS
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Model DGA454, DGA504
Work mode : surface grinding with normal side
grip
Vibration emission (a
h,AG
) : 6.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode : surface grinding with anti vibration
side grip
Vibration emission (a
h,AG
) : 6.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode: disc sanding
Vibration emission (a
h,DS
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG902-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
•
The declared vibration emission value is used for
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-18
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Cordless Angle Grinder
Model No./ Type: DGA404,DGA454,DGA504
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
13.3.2014
000331
Yasushi Fukaya
Director
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
GEA010-1
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
GEB059-4
CORDLESS GRINDER SAFETY
WARNINGS
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
1.
This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool.
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool.
Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury.
2.
Operations such as polishing are not
recommended to be performed with this
power tool.
Operations for which the power tool
was not designed may create a hazard and cause
personal injury.
3.
Do not use accessories which are not
specifically designed and recommended by
the tool manufacturer.
Just because the
accessory can be attached to your power tool, it
does not assure safe operation.
