6 / 9
4-3
Switch/ Sensor, Terminal section/ Board
4-3-1
Disassembling
Fig.8
1
Remove Switch trigger [1] carefully so that Spring
[2] does not pop out.
Fig.9
2
Remove Screw 3 *10 [1], then remove the
following parts:
Switch [2]
Trigger spring-fixed block [3]
Digital display [4]
Clamp [5]
Fig.10
3
Loosen Screws 3 *10 [1] (2 pcs), then remove
Power on/off [2].
Fig.11
4
Disconnect Connector [2] from PCB board [1], then
remove Terminal protector [3].
5
Remove PCB board [1] and Battery terminal [4]
from Housing.
[2]
[3]
[1]
[4]
[2]
[1]
[1]
[4]
[5]
[3]
[2]
[2]
[1]
