30
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a MAKITA service center.
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service center for all work not described in this instruction manual.
The MAKITA service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest MAKITA service center.
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts
used. Use only original MAKITA parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materi-
als, dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA
product guarantee.
We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts.
Page
General
Entire Power Cut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Cutting disc
Inspect regularly for damage and wear.
7
Clutch
Have inspected at a service center.
Protection hood
Clean, Check position (impact plate)
18
Before each start
Cutting disc
Inspect for damage and make sure the cutting wheel is
7
right for the job
V-belt
Check V-belt tension
15
Protective hood
Adjust position
Combination switch,
Functional check
Safety locking button,
Functional check
Throttle lever
Functional check
18
Tank cap
Check for tightness and lekages
Every day
Air filter
Clean (if necessary more frequently); pre-filter (foam)
maintenance as described above under
Cleaning /
changing the air filter
22-23
Idle speed
Check (cutting disc must not turn on idle)
20
Extreme dust
Clean filter insert (paper cartridge)
22-23
Every week
Starter housing
Clean to ensure proper air cooling
13
Starter cable
Check for damage
25
V-belt
Check V-belt tension, inspect for damage and wear
15, 21
Air filter insert
Clean, replace after 100 operating hours
22-23
Spark plug
Check and replace if necessary
24
Muffler
Check tightness of mounting, clean or replace
13 / 28
spark arrester screen if necessary
Screws an nuts
Check their condition an that they are firmly secured
Every 3 months
Suction head
Replace
24
Fuel tank
Clean
Annually
Entire Power Cut
Check at an authorized service center
Storage
Entire Power Cut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Cutting disc
Remove and clean
14
Fuel tank
Empty and clean
Carburetor
Run empty
