4 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
DPV300
Maximum capacities
Wool pad
80 mm
Sponge pad
80 mm
Sanding disc
50 mm
Backing pad diameter
For sanding
46 mm
For polishing
75 mm
Rated speed (n) /
No load speed (n
0
)
High (2
):
sanding mode
0 - 9,500 min
-1
Low (1
):
polishing mode
0 - 2,800 min
-1
Overall length
160 mm *1
Rated voltage
D.C. 18 V
Net weight
1.3 - 1.6 kg
*1. With battery cartridge (BL1860B).
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications and battery cartridge may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi
-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
Charger
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above.
Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and
paint.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745-2-3:
Sound pressure level (L
pA
) : 73 dB(A)
Uncertainty (K) : 3 dB(A)
NOTE:
The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE:
The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745-2-3:
Work mode: disc sanding
Vibration emission (a
h, DS
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Work mode: polishing
Vibration emission (a
h, P
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
