7
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12
mm
(
15
/3
2
”)
9
mm
(3/8”)
001266
Use only bits that has inserting portion shown in the
figure.
1
2
011406
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
1
2
011406
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
•
If the bit is not inserted deep enough into the sleeve,
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
•
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook
1
2
3
012787
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
OPERATION
012788
CAUTION:
•
Do not cover vents, or it may cause overheating
and damage to the tool.
1
012912
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
1. Vent
1. Groove
2. Hook
3. Screw
1. Bit
2. Sleeve
1. Bit
2. Sleeve
