7 ENGLISH
Reversing switch action
1
A
B
►
1.
Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun
-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
•
When not operating the tool, always set the
reversing switch lever to the neutral position.
Speed change
1
►
1.
Speed change lever
NOTICE:
•
Always set the speed change lever fully to the cor
-
rect position. If you operate the tool with the speed
change lever positioned halfway between the "1"
side and "2" side, the tool may be damaged.
•
Do not use the speed change lever while the tool
is running. The tool may be damaged.
•
Do not force the lever to "1" side with impact driver
mode. The tool may be damaged.
To change the speed, first switch off the tool and then
slide the speed change lever to the "2" side for high
speed or "1" side for low speed. Be sure that the speed
change lever is set to the correct position before opera-
tion. Use the right speed for your job.
When turning the action mode changing ring to impact
driver mode, set the speed change lever to the "2" side.
Selecting the action mode
1
2
3
►
1.
Mode mark
2.
Action mode changing ring
3.
Arrow
This tool employs an action mode changing ring. Select
one of the 4 modes suitable for your work need by
turning this ring.
When driving wood screws or bolts, point the arrow at
the
mark for impact driver mode. The impact force
can be adjusted on the LED display.
When drilling into concrete or tiles, point the arrow at
the
mark for hammer drill mode.
When drilling into wood or metal, point the arrow at
the
mark for drill mode.
When driving small wood screws or machine screws,
point the arrow at the
mark for screwdriver mode.
The fastening torque can be adjusted on the LED
display.
CAUTION:
•
Always set the arrow correctly to either mode
mark. If you operate the tool with the action
mode changing ring positioned halfway between
the mode marks, the tool may be damaged.
•
When turning the action mode changing ring,
make sure that the tool stops. If the ring does
not easily move, pull the switch trigger slightly to
rotate the spindle and then move the ring.
•
In the hammer drill mode or drill mode, the blow
-
ing force or torque is not adjustable. In those
modes, the number on the LED display will be
off.
