P 11/ 11
Fig. D-2
Printed wiring
board
Boss A
Rib A
LED circuit
F/R Change lever
Capacitor of Controller
Stator
W
iring diagram
Unit case
complete
Rib B
Switch
Controller
Terminal
Controller
Controller
Lead wires of Terminal
must be put on the tab of
Controller.
Tab of Controller
Stator’s Lead wires (3pcs.)
have to be put on the other
lead wires in this area.
Three Controller’s lead wires they are
connected to Closed end connectors
must be fixed with this lead wire holders.
Put Closed end connectors in this space
while keeping enough distance from
Capacitor of Controller.
Pass Lead wires of LED circuit between Rib A and
Boss A, between Rib A and Unit case complete,
and between Rib B and F/R change lever.
At least Black lead wire of
Terminal has to be put with
this lead wire holder.
Put Connector of
LED circuit here.
Do not put any lead wires
on these Ribs.
Be careful not to give damage
to Printed wiring board and
its lead wires when assembling
them in the place here.
