11
ENGLISH
For impact socket with O-ring and pin
Only for Model DTW1001 / DTW1001XV
Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the
impact socket onto the square drive so that the hole in
the impact socket is aligned with the hole in the square
drive.
Insert the pin through the hole in the impact socket and
square drive. Then return the O-ring to the original posi-
tion in the impact socket groove to retain the pin.
To remove the impact socket, follow the installation
procedures in reverse.
2
3
1
Fig.9
►
1.
Impact socket
2.
O-ring
3.
Pin
Tool with the detent pin
Only for Model DTW1004 / DTW1004XV
Align the hole in the side of the impact socket with the
detent pin on the square drive and push the impact
socket onto the square drive until it locks into place. Tap
it lightly if required.
To remove the impact socket, simply pull it off. If it is
hard to remove, depress the detent pin while pulling the
impact socket.
1
2
3
4
Fig.10
►
1.
Impact socket
2.
Hole
3.
Square drive
4.
Detent
pin
Installing or removing drill bit/
socket adapter
Optional accessory
Only for Model DTW800 / DTW800XV
A
Fig.11
A=11.1 mm
Use only the drill bit/socket adapter shown in the figure.
Do not use any other drill bit/socket adapter.
1
2
Fig.12
►
1.
Drill bit
2.
Sleeve
To install the drill bit, pull the sleeve in the direction of
the arrow and insert the drill bit into the sleeve as far as
it will go.
Then release the sleeve to secure the drill bit.
To remove the drill bit, pull the sleeve in the direction of
the arrow and pull the drill bit out.
NOTE:
If the drill bit is not inserted deep enough into
the sleeve, the sleeve will not return to its original
position and the drill bit will not be secured. In this
case, try re-inserting the drill bit according to the
instructions above.
NOTE:
After inserting the drill bit, make sure that it is
firmly secured. If it comes out, do not use it.
