8
OPERATION
Blowing (Fig. 10)
CAUTION:
• Do not place the blower on the ground while it is
switched on. Sand or dust may enter from suction inlet,
and they may result in personal injury.
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a
vehicle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Cleaning (Fig. 11)
From time to time, wipe off the outside of the tool using a
cloth dampened in soapy water.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Makita genuine battery and charger
• Shoulder belt
• Extension nozzle
• Flat nozzle
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
ENG108-1
Noise
The typical A-weighted noise level determined according
to EN50636:
Sound pressure level (L
pA
): 79.1 dB (A)
Uncertainty (K): 1.8 dB (A)
Sound power level (L
WA
): 93.5 dB (A)
Uncertainty (K): 2.3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN50636:
Work mode: operation without load
Vibration emission (a
h
): 2.5 m/s
2
or less
Uncertainty (K): 1.5 m/s
2
ENG901-1
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
EC DECLARATION OF CONFORMITY
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
Summary of Contents for DUB362PT4X
Page 3: ...3 9 015482 10 015484 11 015483...
Page 50: ...50 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Makita 21 22 23 24 25 26 27 28 29...
Page 52: ...52 015485 60 2 B 75 100 50 75 25 50 0 25 015658 3...
Page 53: ...53 50 100 20 50 0 20 015527 4 5 OFF 6 1 6 6 1 6 1 6 7 8 1 2 9 10 11 Makita Makita...
