Makita DUR361U Instruction Manual Download

Page: 15 / 172

Speed adjusting dial

Fig.11

The tool speed can be adjusted by turning the adjusting
dial. Turn the speed adjusting dial clockwise for higher
speed, and counterclockwise for lower speed.

Nylon cutting head (optional accessory for a
product that comes with a cutter blade)
Nylon cutting head

NOTICE:

•

Do not attempt to bump feed the head while the tool
is operating at a high RPM. Bump feeding at a high
RPM may cause damage to the nylon cutting head.

•

The bump feed will not operate properly if the
head is not rotating.

Fig.12

The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating at a
low RPM.

NOTE:

If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under “Maintenance” .

ASSEMBLY

WARNING:

•

Always be sure that the tool is switched off
and battery cartridge is removed before
carrying out any work on the tool.

Failure to

switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.

•

Never start the tool unless it is completely
assembled.

Operation of the tool in a partially

assembled state may result in serious personal
injury from accidental start-up.

Installing the handle

For model DUR361U

Fig.13

Insert the shaft of the handle into the grip as shown.
Align the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
Fit the barrier and grip onto the shaft pipe with four screws.
Make sure that the spacer on the shaft pipe is located
between the grip/barrier assembly and the hanger.

Fig.14

Place handle between handle clamp and handle holder.
Adjust the handle to an angle that provides a
comfortable working position and then secure by firmly
hand-tightening knob.

For model DUR362L

Fig.15

Fit the grip onto the shaft pipe and tighten it with two
hex bolts. Make sure that the spacer on the shaft pipe is
located between the grip assembly and the other grip.
Do not remove or shrink the spacer.

Installing the guard

WARNING:

•

Never use the tool without the guard illustrated
in place.

Failure to do so can cause serious

personal injury.

For cutter blade (only for model DUR361U)

Fig.16

Fig.17

Install the protrusion of the protector clamp to the gear
case until aligning the position with the label on the pipe.
Fix the protector to the protector clamp with the two bolts and
then tighten both bolts by the hex wrench evenly.

For nylon cutting head

For DUR362L

Fig.18

Align the protrusions on the protector attachment with
the grooves of the protector.

Fig.19

Align the protrusions on the protector holder attachment
with the groove of the protector holder.

Fig.20

After attaching the protector and the protector holder,
tighten the hex bolts securely.
For DUR361U (optional accessory)

Fig.21

Remove the hex bolts with hex wrench. Then remove
the protector clamp and protector.

Fig.22

Install the protector attachment and protector holder
attachment to the gear case.
To install the protector for nylon cutting head, follow the
installing method mentioned previously.

Installing the wire guard

CAUTION:

•

Before adjusting the wire guard, wait for the
cutting head comes to standstill. Do not adjust the
wire guard with your foot.

Fig.23

To reduce the risk damaging the objects in front of the
cutting head, insert the wire guard so that it controls the
cutting range of the mowing line.

Fig.24

Slightly expand the wire guard outward and then insert it
into the holes of the protector.

Та

ше

Га

лв