33 / 71
4-5-6
Assembling Carburetor
Fig. 71
1
Assemble Carburetor by reversing the disassembly
procedure.
2
Clean up the parts with gasoline or the like, and then
blow away the gasoline with air duster gun or the like.
Note
Do not blow air at a high pressure.
3
If Pump diaphragm [3] and Metering diaphragm [5] are
deformed/ hardened/ damaged/ corroded, replace them
with new ones.
4
While pressing down Lever [1], install Screw [2], and
then make sure that Lever [1] is movable.
5
Match the two holes of Pump gasket and Pump
diaphragm [3] with the positioning pins of Carburetor
body, and then install Pump body assembly [4] on
Carburetor body.
6
Match the two holes of Metering diaphragm gasket and
Metering diaphragm [5] with the positioning pin of
Pump body assembly, and then assemble Metering
diaphragm cover to Pump body assembly.
7
Adjust Adjust screw [6] so that the clearance is 1.0 to
2.0mm.
[1]
[2]
[3]
[4]
[5]
1R217
[6]
