56 / 71
Fig. 130
42
Push each Tube to Cylinder securely onto the nipple of
each part until it stop. The clearance between them
should be 1.0mm or less.
Fig. 131
43
Install Exhaust port spacer [1] on Cylinder block [2].
Tips
The orientation of Exhaust port spacer [1] does not matter.
Fig. 132
44
By tightening three M6x20 Hex socket head bolts,
fasten Muffler [1] and Muffler gasket [2] to Cylinder
block.
Note
Do not reuse Muffler gasket [2]. Be sure to replace it
with a new one.
The bolt holes can be easily misaligned in tightening
operation. So, before tightening securely, be sure to
provisionally tighten the three bolts to align the bolt
holes.
Fig. 133
45
Attach the 0.30mm leaf of 1R366 to the magnet of
Flywheel [1] as shown on the left, and then place
Ignition coil so that the iron core of Ignition coil
touches the 0.30mm leaf.
1R366
[1]
[1]
[2]
[1]
[2]
1.0mm
MAX
