60 / 71
4-5-13
Connecting Control cable to Blower body (for Model EB5300WH)
Fig. 141
1
Pass the cables through the hole of Frame [1], and then
tighten two 5x20 Tapping screws [2] to fasten Arm
base section [3] to Frame.
Fig. 142
2
Pass the barrel nipple [1] of Control cable through
Adjust screw. Then turn Throttle [2] clockwise and
hold it, and then attach the barrel nipple to Swivel [3].
Tips
Note the orientation of Swivel [3]. If it is oriented wrong,
the barrel nipple cannot be attached.
Fig. 143
3
Fix Control cable [3] in Clamp [2] by tightening 4x14
Tapping screw [1].
Note
Position Corrugated tube [4] so that the end face of
the tube is aligned with the marking (indicated by
the red dotted line) on Front volute case.
Be careful not to twist the cable.
Fig. 144
4
Connect two Straight terminals [1] of Lead unit with
those from Ignition coil and Earth terminal, and then
put the terminals in the space of Front volute case. Put
Control cable [2] and Corrugated tube [3] in place as
shown on the left.
[1]
[2]
[3]
[1]
[2]
[3]
[4]
[1]
[2]
[3]
[1]
[3]
[2]
