8 / 71
4-2-2
Removing Frame, Compression spring 22 (Damper spring), Fan 243 and Front volute case
Fig. 9
1
Remove Frame by removing six M5x16 Hex socket
head bolts [1] as shown on the left.
Note
To prevent the engine section from falling down, put
the machine on a workbench with the Recoil starter
side down.
In the case of 5300WH, before removing Frame [2],
it is necessary to disconnect Control cable and Lead
unit from the engine section and to remove Control
arm. (Refer to 4-4-3.)
Do not fail to remove the two bolts fastening Fuel
tank.
Fig. 10
2
Remove four Compression springs 22 (damper springs)
[1] by turning them counterclockwise.
Note
Two different Compression springs 22 are used:
Two black ones [2] on the Cushion side of Frame
Two silver ones [3] on the bottom side of Frame
Be careful not to mix up the two springs.
Fig. 11
3
Remove ten 5x20 Tapping screws [1] to remove Rear
volute case [2]. Elbow [3] is removed at the same time.
Note
Remove the screws located on both sides of Elbow [3]
last of all to prevent Elbow [3] from falling down.
[3]
[2]
[1]
[1]
[2]
[3]
[2]
[1]
[1]
