16
Feed the cords through the eyelets to come out of the housing.
–
Mount the washer, spring, and spool in the housing.
Align the hooks on the the cover and the housing.
–
Then push cover firmly onto the housing to secure it.
Eyelet
Cover
Hook
Hook
Eyelet
CAUTION: Before doing any work on the equipment, always switch off the
motor and pull the plug cap off the spark plug (see “Checking the
spark plug”).
Always wear protective gloves.
CAUTION: Never remove the recoil starter for yourself, which may cause an
accident. It should be asked to the Authorized Service Agent.
Cleaning of air cleaner
Remove the screw (1).
–
Remove the air cleaner cover (3).
–
Take out the sponge element (2), wash it in lukewarm water and dry it
–
completely.
After cleaning, put back the air cleaner cover (3) and fasten it with screw (1).
–
NOTE: If there is excessive dust or dirt adhering to the air cleaner, clean it
every day. A clogged air cleaner may make it difficult or impossible to
start the engine or increase the engine rotational speed.
To ensure a long service life and to avoid any damage to the equipment, the following servicing operations should be performed at regular
intervals.
Daily checkup and maintenance
Before operation, check the machine for loose screws or missing parts. Pay particular attention to the tightness of the cutting tool.
–
Before operation, always check for clogging of the cooling air passage and the cylinder fins.
–
Clean them if necessary.
Perform the following work daily after use:
–
Clean the equipment externally and inspect for damage.
•
Clean the air filter. When working under extremely dusty conditions, clean the filter the several times a day.
•
Check the cutting tool for damage and make sure it is firmly mounted.
•
Check that there is sufficient difference between idling and engagement speed to ensure that the cutting tool is at a standstill while the
•
engine is idling (if necessary, reduce idling speed).
If under idling conditions the tool should still continue to run, consult your nearest Authorized Service Center.
Check the functioning of the start-stop switch, the lock-off lever, the control lever, and the look button.
–
SERVICING INSTRUCTIONS
(1)
(2)
(3)
Summary of Contents for EM2500L
Page 70: ...70 ...
Page 71: ...71 ...
Page 72: ...Makita Corporation Anjo Aichi Japan EM2500L SEA4 0614 www makita com ALA ...
