Makita GA007G, Instruction Manual

12 ENGLISH

2
3

4

1

►    

1.

 Lock nut 

2.

 Depressed center wheel 

3.

 Inner 

flange 

4.

 Mounting part

To tighten the lock nut, press the shaft lock firmly so 

that the spindle cannot revolve, then use the lock nut 

wrench and securely tighten clockwise.

1

2

►    

1.

 Lock nut wrench 

2.

 Shaft lock

To remove the wheel, follow the installation procedure 

in reverse.

Installing or removing flex wheel

Optional accessory

WARNING:

Always use supplied guard when 

flex wheel is on tool.

 Wheel can shatter during use 

and guard helps to reduce chances of personal injury.

1

2

3

4

►    

1.

 Lock nut 

2.

 Flex wheel 

3.

 Back up pad 

4.

 Inner 

flange

Follow instructions for depressed center wheel but also 

use back up pad over wheel. See order of assembly on 

accessories page in this manual.

Installing or removing abrasive disc

Optional accessory

NOTE:

 Use sander accessories specified in this man

-

ual. These must be purchased separately.

For 100 mm (4″) model

1

2

3

4

►    

1.

 Sanding lock nut 

2.

 Abrasive disc 

3.

 Rubber pad 

4.

 Inner flange

1.

  Mount the inner flange onto the spindle.

2.

  Mount the rubber pad onto the spindle.

3.

  Fit the disc on the rubber pad and screw the sand-

ing lock nut onto the spindle.

4.

  Hold the spindle with the shaft lock, and securely 

tighten the sanding lock nut clockwise with the lock nut 

wrench.
To remove the disc, follow the installation procedure in 

reverse.

For 115 mm (4 - 1/2″) / 125 mm (5″) 

model

1

2

3

►    

1.

 Sanding lock nut 

2.

 Abrasive disc 

3.

 Rubber pad

1.

  Mount the rubber pad onto the spindle.

2.

  Fit the disc on the rubber pad and screw the sand-

ing lock nut onto the spindle.

3.

  Hold the spindle with the shaft lock, and securely 

tighten the sanding lock nut clockwise with the lock nut 

wrench.
To remove the disc, follow the installation procedure in 

reverse.