Makita GA007G, Instruction Manual

14 ENGLISH

For 100 mm (4″) model

When installing the abrasive cut-off wheel:

16 mm (5/8″)

16 mm (5/8″)

1

1

4

4

2

3

►    

1.

 Lock nut 

2.

 Abrasive cut-off wheel (Thinner than 4 

mm (5/32")) 

3.

 Abrasive cut-off wheel (4 mm (5/32") 

or thicker) 

4.

 Inner flange

When installing the diamond wheel:

1

1

4

4

2

3

►    

1.

 Lock nut 

2.

 Diamond wheel (Thinner than 4 mm 

(5/32″)) 

3.

 Diamond wheel (4 mm (5/32″) or thicker) 

4.

 Inner flange

For 115 mm (4 - 1/2″) / 125 mm (5″) 

model

When installing the abrasive cut-off wheel:

1

1

4

4

2

3

►    

1.

 Lock nut 

2.

 Abrasive cut-off wheel (Thinner than 4 

mm (5/32")) 

3.

 Abrasive cut-off wheel (4 mm (5/32") 

or thicker) 

4.

 Inner flange

When installing the diamond wheel:

1

1

4

4

2

3

►    

1.

 Lock nut 

2.

 Diamond wheel (Thinner than 4 mm 

(5/32″)) 

3.

 Diamond wheel (4 mm (5/32″) or thicker) 

4.

 Inner flange

Installing wire cup brush

Optional accessory

CAUTION:

Do not use brush that is damaged, 

or which is out of balance.

 Use of damaged brush 

could increase potential for injury from contact with 

broken brush wires.

1

►    

1.

 Wire cup brush

Remove the battery cartridge from the tool and place it 

upside down allowing easy access to spindle.

Remove any accessories on spindle. Thread wire cup 

brush onto spindle and tighten with supplied wrench.

Installing wire wheel brush

Optional accessory

CAUTION:

Do not use wire wheel brush that 

is damaged, or which is out of balance.

 Use of 

damaged wire wheel brush could increase potential 

for injury from contact with broken wires.

CAUTION:

ALWAYS use guard with wire 

wheel brushes, assuring diameter of wheel fits 

inside guard.

 Wheel can shatter during use and 

guard helps to reduce chances of personal injury.