Makita GA4041, Technical Information

P 3/ 14

R

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -2. Armature, Spiral bevel gear [small one]

DISASSEMBLING

(1) Remove Spiral bevel gear (small) from the drive end of Armature as drawn in 

Fig. 2

.

Fig. 2

1. Remove Rear cover by unscrewing 

    one 4x18 Tapping screw.

4x18 Tapping screw

4x50 Tapping screw

4. Unscrew four Tapping screws. Then separate Gear housing cover from Spacer while applying a slotted 

    screwdriver to the notch on Gear housing cover on belly side. 

Rear cover

2. Shift Spiral spring from

    Carbon brush top.

3. Disconnect Carbon brush from

  commutator by pulling up.

Note

: No need to remove Carbon

   brush 

in this step.

Notch on

Gear housing cover

Gear housing cover

Armature

Gear housing

cover
Compression

spring 33

Brake shoe

holder complete

5. Remove M6 Hex nut to turn it with Wrench 10

    counterclockwise. Then, remove Flat washer 6

    and small Spiral bevel gear from Armature.

6. Remove Gear housing cover with 1R045.

    Then, remove Compression spring 33 and

    Brake shoe holder complete.

Caution

: Be careful that the cover and the spring

                may jump out from Armature side

                due to recoil force by the spring.

Flat washer 6
Spiral bevel 

gear (small) 

M6 Hex nut

1R045

Gear housing cover

Gear housing

Spacer

Wrench 10

Armature